Model Planes

It contains photo-etched part s, floor, seat, instrument panel, seatbelts, control column, fuselage guns...

Kit-set contains: Resin Casting Parts: Fuselage, wings (1,2 mm steel wire reinforced), horizontal and vertical fins, ailerons, tail wings. 3D printed parts: - Full Interior, propellers (2 types), undercarriage. - Spoked wheels included to the model, solid wheels. - All struts, strong black ABS PRO r..

Kit-set contains: Resin Casting Parts: Fuselage, wings (1,2 mm steel wire reinforced), horizontal and vertical fins, ailerons, tail wings. 3D printed parts: - Full Interior, propellers (2 types), undercarriage. - Spoked wheels included to the model, solid wheels. - All struts, strong black ABS PRO r..

..

..

resin parts for 3 Cannon version , Czechoslovak decals for 5 Versions..

40x brass parts..

40x brass parts..

This is a plastic model kit, which comes unassembled and unpainted. So glue, model paints and other basic modelling tools are additionally required...

new parts: - fuselage front cover - rear fuselage fin - photo gun - fuselage pitot tube - antenna - brass barrel include: photoetched parts, 3x resin parts, brass part..

The Caudron G.3 was a single-engined French biplane built by Caudron, widely used in World War I as a reconnaissance aircraft and trainer.- High-quality Cartograf decals- 106 high-quality injection moulded plastic parts- Highly detailed Le Rhone 80 HP engine- 10 photo-etched metal detail..

The Caudron G.3 was a single-engined French biplane built by Caudron, widely used in World War I as a reconnaissance aircraft and trainer.- High-quality Cartograf decals- 135 high-quality injection moulded plastic parts- Highly detailed Anzani 100 HP engine- 10 photo-etched metal detail ..

The Bucker Bu 181 was structurally based on the successful sports and training biplanes Bucker Bu 131 and Bu 133. Unlike them, however, the Bu 181 was a low-wing aircraft with fixed landing gear and a covered cockpit. The wing and tail structure was wooden, partially covered with plywood, the remain..

The Bristol Scout was a single-seat rotary-engined biplane. It was used by the RNAS and the RFC as a "scout", or fast reconnaissance type. It was one of the first single-seaters to be used as a fighter aircraft.All later-built fighters continued to be called "scouts" in British usage into the ear..

** This model kit is supplied in unassembled and unpainted plastic components. Please note that glue, model paints, and other basic modelling tools are required and sold separately...

2 brass parts..

3D Decals Instructions - Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model. - For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface. - Avoid leaving the decal in water for too long, as this may ca..

Paint Mask:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model ..

Paint Mask:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model ..

Paint Mask:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model ..