Hobby & Model Paints

APPLICATION GUIDE-PLASTIC MODELS: For use on injection plastic kits a primer is necessary. 'Regular ALCLAD' is similar in strength to lacquer/cellulose car paints-injected polystyrene plastics frequently have areas which ALCLAD can craze. High-Shine ALCLAD finishes require a glossy base coat. Apply..

Shake thoroughly before use. Do not thin. Apply over Aclclad Bright Silver Candy Base. Spray light coat at 20-25PSI. Wait 5 minutes. Apply further even coasts. Allow 5 minutes between each coat. Leave to cure for 2 hours before handling...

Shake thoroughly before use. Do not thin. Apply over Aclclad Bright Silver Candy Base. Spray light coat at 20-25PSI. Wait 5 minutes. Apply further even coasts. Allow 5 minutes between each coat. Leave to cure for 2 hours before handling...

Shake thoroughly before use. Do not thin. Apply over Aclclad Bright Silver Candy Base. Spray light coat at 20-25PSI. Wait 5 minutes. Apply further even coasts. Allow 5 minutes between each coat. Leave to cure for 2 hours before handling...

Super thin epoxy for wing skinning, laminating and moulding.Use with lightweight glass cloth to add strength and toughness to models...

For brush or spray application.Touch dry in 5-10 minutes for dust free finish.Of all the finishes you can apply Aerokote is the ultimate. Resistant to hot alcohol, gasoline or kerosene containing high nitro methane and mineral, castor, synthetic ester, or poly-glycol synthetic oils...

Converts Aerokote Gloss to satin or matt finish. A simple matting agent that blends readily with Aerokote gloss to give it a satin or matt finish. Just measure & add ??Make it Matt?? to Aerokote Gloss in the quantities as tabulated below and then add standard Aerokote catalyst to the mix in ratio 1..

..

..

..

..

..

..

..

..

..

..

..

Permanent, quick drying varnish and satin finish. Formula 100% acrylic with UV resistance. Can be apply with airbrush or varnishing brush. It is recommended to apply two coats of varnish, with an interval of at least 4 hours. Quick drying varnish can be diluted with water if desired...

..

UsageA solvent-based varnish that goes on clear and dries clear, overcoming the yellowing effect associated with traditional varnishes. The product dries to a smooth, low-sheen matt finish.SubstrateCommon plastics used to manufacture model kits including polystyrene and ABS, as well as MDF. Satin co..

APPLICATION GUIDE-PLASTIC MODELS: For use on injection plastic kits a primer is necessary. 'Regular ALCLAD' is similar in strength to lacquer/cellulose car paints-injected polystyrene plastics frequently have areas which ALCLAD can craze. High-Shine ALCLAD finishes require a glossy base coat. Apply..

APPLICATION GUIDE-PLASTIC MODELS: For use on injection plastic kits a primer is necessary. 'Regular ALCLAD' is similar in strength to lacquer/cellulose car paints-injected polystyrene plastics frequently have areas which ALCLAD can craze. High-Shine ALCLAD finishes require a glossy base coat. Apply..

Apply one of these primers before using High Shine ALCLAD: - ALCLAD GLOSS BLACK BASE ALC-304/305 - ALCLAD CLEAR BASE ALC-303 (Other hobby enamel paints are suitable-it is advisable to conduct a test on scrap plastic)PREPARATION AND SPRAYING The surfaces to be painted must be thoroughly cle..