Model Planes

3D printed seat for Ar 234 Hasegawa, Hobby 2000 kit..

This set offers the open electronics compartment in the nose section of the widely used MB-326 trainer aircraft model kit...

..

..

..

3D Decals Instructions - Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model. - For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface. - Avoid leaving the decal in water for too long, as this may ca..

The kit contains a water-stick decal sheet designed exclusively for model kits.The set including 3 decal sheet Fitted for the Hasegawa and Hobby Boss kits. We corected the markings from original photos...

The kit contains a water-stick decal sheet designed exclusively for model kits. The set including 2 decal sheet Fitted for the Hasegawa and Hobby Boss kits. We corected the markings from original photos...

Vinyl Mask..

Vinyl Mask..

Vinyl Mask..

Vinyl Mask..

3D ResinThis set includes two (2) XM158A1 Rocket Launchers.The Launcher was a seven-tube, reloadable, reusable, repairable 2.75" rocket launcher M158A1 was a variant of the M158 that included a modified hardback mount..

This is a resin model kit, which comes unassembled and unpainted. So glue, model paints and other basic modelling tools are additionally required...

3D ResinThis is a two piece 3D printed set of the SATCOM antenna mounted to the top of the main rotor mast on the UH-1Y Helicopter.Simply glue the antenna to the top center of the base, paint and attach to your model. Parts come ready to install with no clean up required...

..

..

With full stencils of the interior (without cockpit) rotor and B8V20 Rocket POD.The kit contains a water-stick decal sheet designed exclusively for model kits...

The kit contains a water-stick decal sheet designed exclusively for model kits...

The kit contains a water-stick decal sheet designed exclusively for model kits...

3D ResinSet of four (4) 3D printed launchersIn January of 1987, AAC-829 was introduced and by May of 1988, over 6500 launchers had been modified to LAU-7/A-6.Over the course of the next several years, numerous AAC's changed the designation of the launcher to B/A, A-7, B/A-1, as well as a few oth..

3D ResinThis set includes two empty LAU-68F/A pods. The F/A is 11 inches longer than the LAU-68D/A and is used exclusively with the 2.75 APKWS rockets. Pod is used by the F/A-18, AV-8B, AH-1Z, UH-1Y, A-10, F-16 and a number of other aircraft.Pods are 3D printed and come ready to paint and attach t..

3D Resin..

3D ResinThis set contains two (2) LAU-10 5.00" rocket pods with empty tubes. Tubes are hollow the whole length of the pod.Designed by Matt Farrow of Shrunk Craft..