Model Planes

3D Decals Instructions - Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model. - For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface. - Avoid leaving the decal in water for too long, as this may ca..

3D-Printed & coloured parts on decal paper..

3D-Printed & coloured parts on decal paper..

..

..

..

..

..

3D-Printed & coloured parts on decal paper..

..

Formation Lights (Type A) (for all kits)..

3D-Printed & coloured parts on decal paper..

Please note that the plane in photo is just for display but NOT included in this set...

..

3D-Printed & coloured parts on decal paper..

DZUS Fasteners (all kits)..

Please note that the plane in photo is just for display but NOT included in this set...

3D Decals Instructions - Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model. - For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface. - Avoid leaving the decal in water for too long, as this may ca..

..

3D Decals Instructions - Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model. - For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface. - Avoid leaving the decal in water for too long, as this may ca..

..

..

..

..