Model Cars

size of rim: 1.8cm..

This is an upgrade parts set for increasing details like the headlight rim and other locations. For MFH's "1/12 scale 250GTO" use only.- For increasing details to parts like Light Rim, Mirror, Meter Rim, the Belt connectors, emblem base. Made of brass in form of photo etch sheet.- Use a solde..

..

Water-slide Decals: Instruction: 1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them. 2. Cut out the decal you need (do it on cutting mat) 3. Grab the..

(Type: model figures) This is a resin model kit, which comes unpainted. So model paints and other basic modelling tools are additionally required.*NOTE: This model kit is NOT recommended for small children without parental supervision...

Type: water-slide decalsHow to apply water-slide decals:1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.2. Cut out the decal you need (do it on cutting m..

How-to:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model by traci..

NOTE: This kit only includes one unpainted resin figure...

NOTE: This kit only includes one unpainted resin figure...

NOTE: This kit only includes one unpainted resin figure...

NOTE: This kit only includes one unpainted resin figure...

*NOTE: The set does NOT include any car model kit.The set contains the following parts: 4x wheel rings (OD 18.2mm) 4x wheel inserts, 4x tyres, tyre diameter: 22mm..

..

..

..

..

..

..

How to apply water-slide decals:1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.2. Cut out the decal you need (do it on cutting mat)3. Grab the decal wit..

..

..

..

..

..