Military Vehicles & Tanks

Products made in 3D are not assembled or painted, and there may be colour differences depending on the resin.Experience in removing 3D parts is useful but not essential. Any supports connected to the detail can be cut with side cutters or a slitting disc; the remainder can be broken off with snip..

Products made in 3D are not assembled or painted, and there may be colour differences depending on the resin.Experience in removing 3D parts is useful but not essential. Any supports connected to the detail can be cut with side cutters or a slitting disc; the remainder can be broken off with snip..

click together tracks and sprockets, no glue required 3d printed 1/35 scaleProducts made in 3D are not assembled or painted, and there may be colour differences depending on the resin.Experience in removing 3D parts is useful but not essential. Any supports connected to the detail can be cut with..

This is an etching upgrade kit, model kit is not included...

..

..

Lewis MG w/Scarff Mount for RR Armored Cars (all models on the market).Equisit proposition for allied vehicles fans, and the iconic RR armored car. This is one of the two types of mount, we call it type A.Highly detailed 3D printed aftermarket set, comprises of 3 separate parts - turret ring, m..

..

3D Decals Instructions - Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model. - For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface. - Avoid leaving the decal in water for too long, as this may ca..

3D Decals Instructions - Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model. - For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface. - Avoid leaving the decal in water for too long, as this may ca..

..

..

..

This is a resin model kit, which comes unassembled and unpainted. So glue, model paints and other basic modelling tools are additionally required...

..

NOTE: This is only an aftermarket set that does NOT include the vehicle model...

Components- Photo Etching 4 sheets(Brass 0.15mm) - 3D-Printed parts - Manual (2 pages)..

Components- Photo Etching 4 sheets(Brass 0.15mm) - 3D-Printed parts - Manual (2 pages)..

..

..

..

Type: water-slide decalsHow to apply water-slide decals:1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.2. Cut out the decal you need (do it on cutting m..

3D Decals Instructions - Soak the decal in warm water for a few seconds. Once it separates from the backing paper, position it on the model. - For better adhesion, use white glue, Mr. Mark Setter, or apply the decal to a glossy surface. - Avoid leaving the decal in water for too long, as this may ca..

..