Military Vehicles & Tanks

Full resin kit of one of the most widespread German small calibre Anti Aircraft device from the end of World War II. The swivel mount with three 20 mm MG 151/20 cannons was highly efficient not only against low flying aircraft but also against light armoured enemy vehicles. The ''Drilling'' was at t..

..

Contains two types of both front and rear towing eyes for German Hetzer tank hunter kit...

Highly detailed parts for converting Jagdpanzer 38 Hetzer into ST-III School version...

Contains one piece of gun mantlet for German Hetzer tank hunter kit. This mantlet was mounted on the prototype and on first few early production vehicles...

Contains one gun mantlet for WW 2 German tank fighter Hetzer. It is lightened type...

Contains one piece of gun mantlet for German Hetzer tank hunter kit. This mantlet was mounted on the early production vehicles...

Superbly detailed resin cast wheels with weighted tyres are designed for the new Austin K2 Ambulance model...

The MG 34 machine gun depicted here is with its mounting as used on a motorbike sidecar. The ammo magazine was usually under the gunner's feet in the sidecar. Our 3D-printed set possess almost extreme detail levels compared to the original kit styrene item...

The Vickers machine gun was developed on the basis of the earlier Maxim weapon. The design prouded itself with great efficacy as well as almost a hundred percent reliability. These technically perfect Vickers guns were produced in really great numbers both for the army (these were water-cooled) and ..

Detailed cast wheels for the front axle of the V3000S/SSM Maultier half-track vehicle kit by ICM. This kit is also reboxed by Revell...

The German Sd.Kfz 251 armoured personnel carrier was most often equipped with a pair of machine guns, a forward mounted MG34 with a shield and a rear one of the same type on an anti-aircraft, hinged mount at the rear of the combat compartment where it was employed both against aerial and ground targ..

3D-printed set portraying the MG3 machine gun with an ammo box on a mount specific to the Leopard tank. Comes with a fret of etches...

The Leichter Ladungstrager, also known as the Goliath, was a small, wire-guided destruction vehicle used by the German Wehrmacht during WW2. It resembled a tiny tank sans the turret and was capable of carrying up to 60 - 100 kg of explosives to the target area where the charge was set off. Two varia..

..

Turned metal barrel..

For the rather rusty, yet still very popular Tamiya DKW NZ 350 kit, we have prepared this set that replaces more than a half of the kit's original parts. The reason is that the very old kit quite fails modern standards and the wheels are made one piece with the frame - which gives the bike almost to..

..

Detail muzzle brake cast for a model of the Czechoslovak anti-tank gun that was used by the German Wehrmacht and other armies as well during WW2. The brake has apertures around its circumference, was designed in 3D and the master pattern was produced using a 3D printer to achieve the best quality. E..

..

..

..

There are two cables included. Each one is around 9cm in length...

..