Barracuda BC-48002 1/48 P-47 Thunderbolt Part 2 Decals
Out Of Stock
"Kansas Tornado II" P-47D-25-RE, serial number 42-26742. 510th FS, 405 FG, 9th Air Force. Flown by Capt. Howard Curran. Based at St. Dizier, France, Fall, 1944. Natural metal finish with dark blue nose ring and canopy frames. Note cutback cowl flaps and Curtiss Electric 13' paddle bladed propeller.
"Angie" P-47D-27-RE, serial number 42-26860. 512th FS, 406th, FG 9th Air Force. Flown by Col. Anthony Grosetta. Based at Asch, Belgium, early 1945. Natural metal finish yellow trim and polished olive drab (not black) tailplanes. Note Curtiss Electric 13' paddle bladed propeller and lighter blue stripe on the tail.
"Little Ann" P- 47D-27-RE, Serial number 42-26922. 512th FS, 406th, FG 9th Air Force. Pilot unknown. Based at Asch, Belgium, early 1945. Natural metal finish yellow trim. Lower fuselage splattered with dried mud. Note Curtiss Electric 13' paddle bladed propeller and dark blue stripe on the tail (overlay blue stripe from addendum sheet).
How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.
"Angie" P-47D-27-RE, serial number 42-26860. 512th FS, 406th, FG 9th Air Force. Flown by Col. Anthony Grosetta. Based at Asch, Belgium, early 1945. Natural metal finish yellow trim and polished olive drab (not black) tailplanes. Note Curtiss Electric 13' paddle bladed propeller and lighter blue stripe on the tail.
"Little Ann" P- 47D-27-RE, Serial number 42-26922. 512th FS, 406th, FG 9th Air Force. Pilot unknown. Based at Asch, Belgium, early 1945. Natural metal finish yellow trim. Lower fuselage splattered with dried mud. Note Curtiss Electric 13' paddle bladed propeller and dark blue stripe on the tail (overlay blue stripe from addendum sheet).
How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.
| General Info | |
| Scale | 1/48 |
| Type | Model Upgrade/Accessory |
| Subtype | Decals / Stickers |
| Minimum Age | 14 Years |
- Stock: Out Of Stock
- Reward Points: 18
- SKU: BAR BC-48002
Barracuda
MRP: US$16.13 Save: US$1.80
11% OFF
US$14.33
(incl. Tax)
"In-Stock" Really Means It
Combine Shipping & Save
SAME or Next day shipping*
![1/48 Supermarine Spitfire Mk.VIII [Weekend Edition]](/image/cache2/235x235_contain/catalog/eduard/ED84154.jpg?v=13)
1/48 P-51D Mustang Weekend Edition Paint Masking Sheet for Eduard kits
1/48 P-51D Mustang Weekend Edition Paint Masking Sheet for Eduard kits
Eduard • ED EX740
US$7.72
US$8.78
12%
There are no reviews
Maybe you can help? Many users will be grateful to you. And so are we.