Decals for 1/48 Boeing B-17 Flying Fortress

1. B-17F in the 388th Bomb Group on the plane Veni Vidi Vici. He completed his 25 missions on 20 Feb 44.
The next crew that took that plane diverted into Sweden and the crew and plane were interned.
That aircraft was refurbished and used by the Swiss to make the first commercial flight across the Atlantic after the war and landed at La Guardia Airport.

Water-slide Decals:
Instruction:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softener is also recommended at this stage. After applying softener, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.