Print Scale 32-022 Decals for 1/32 Grumman TBF Avenger

1. This TBM-3S (Y-AR, 53682) was assigned to Number 880 Squadron (later VS-880), Royal Canadian Navy (RCN) at RCN Air Station Shearwater, Nova Scotia in 1952. The aircraft- locally designated the Avenger AS Mark 3-was used for anti-submarine patrols off Canadas Atlantic coast between 1950 and 1957. This Avenger retained the USN finish of overall Glossy Sea Blue.
2. TBF-1C, White 97 (BuNo 48102),was assigned to Torpedo Squadron 2 (VT-2) aboard the carrier USS HORNET (CV-12) during the summer of 1944. The VT-2 insignia was displayed on the forward fuselage, while the white disc on the vertical stabilizer identified the HORNETs Carrier Air Group 11 (CVG-11). This Squadron participated in the Battle of the Philippine Sea on 19-20 June.
3. Lt (JG) George Bush- the future 41st President of the United States - flew this TBF-1C, while assigned to VT-51aboard the USS SAN JACINTO (CVL-30) in the western Pacific in the fall of 1944. He named the Avenger BARBARA for his fiancee, Barbara Pierce. Bushs aircraft was shot down while attacking the Japanese-held island of Chichi Jima on 2 September 1944.
His turret gunner and radio operator/bdombardier were killed; however, Bush safely parachuted from the stricken TBF and was rescue by the submarine USS FINBACK (SS-2300).
4. White 110 was a TBM-3 assigned to VT-82 adoard the USS BENNINGTON (CV-20) in February of 1945.The aircraft was overall Glossy Sea Blue FS 15042 , with Glossy Insignia Blue FS 15044 and Glossy Insignia White FS 17855 national markings. The white arrowhead on the rudder and the upper starboard and lower port ailerons was the BENNINGTON??s air group insignia. In early 1945, VT-82's Avengers attacked enemy targets in Japanese home islands.

Water-slide Decals:
Instruction:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface