RAYMOCO RC48.101.00 1/48 MiG-21 Detail set: Engine R-13F-300, Radar, Electronics, Tail Hydraulics

Products made in 3D are not assembled or painted, and there may be colour differences depending on the resin.

Experience in removing 3D parts is useful but not essential. Any supports connected to the detail can be cut with side cutters or a slitting disc; the remainder can be broken off with snips or by applying pressure with a fingernail.
There is extremely fine detail, so great care is needed to avoid breakage.

Keep out of strong light until you remove from the pad and apply primer. Exposure to light may continue to cure items, causing them to warp or become brittle. The pads may curl slightly (even when left in the dark) due to the stresses in the resin from the printing process.
#Caution: Never boil in hot water as it can cause damage. If the product is bent, using the heat of a hair dryer can help straighten it.