Micro sol setting solution is for the most difficult irregular surfaces you find on models. It completely softens the decal allowing it to drape down onto the surface of the model conforming perfectly and without distortion. You can get the most amazing results in seemingly impossible places, because micro sol actually makes the decal part of the paint. For that reason you should coat micro sol on for only a few seconds and then leave it alone, it does the work. Do not touch until dry as the decal is very soft at this stage and could be easily damaged.
1. Brush Micro Set (part 1 of the 2 step system) on the model where the decal is to be applied, then dip decal in water and slide off backing paper into position on the model.
2. Using a soft brush, gently apply Micro Sol onto the decal during application. Do not touch decal after applying Micro Sol, as the decal is now soft and can easily be distorted. Allow decal to dry completely.
3. On surfaces with many irregularities, addtional applications may be necessary. Allow Micro Sol to dry between applications. If air bubbles become trapped under the decal, prick with a needle and apply Micro Sol.
This product is currently not in stock. Would you please enter the following info and we will notify you once it becomes available. Thank you!