1/72 Wet Decals - Messerschmitt Bf.108 "Taifun" (1 sheet)

Type: water-slide decals
1. Messerschmitt Bf.108B-1 CI+CU, Luftwaffe-unit not known 1941-1942 ??.
2. A Soviet Messerschmitt Bf 108B-1tested in NIVVS in 1940.
3. Bf 108B-1 part: 15 (Kroat)./JG 52 number: BD JG aircraft had been used by Croatian pilots as a liaison to the Black Sea front. September 19, 1942 four pilots on board flew into the Uman to take four fighter Bf 109 g-2.
4. MesserschmittBf 108B-2/Trop Part: not available number: KG EM Cagliari, Sardinia, 1942 ??.
5. Bf 108B- 2 number: FE-4610 Af

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.