Print Scale 72-138 1/72 Wet Decals - Potez 63 (1 sheet)

Type: water-slide decals
1. Potez 63.11 No.366 (C-865) of G.R. II/14 bearing both insignia of 3/13 and 4/13 Sqn. on the fin Avignon 1941.
2. Potez 631 C3 Part 4: Escadrille, GCN II/13, Armee de l'Air number: 186, 2, X-955 (N186) Nimes Courbessac, July 1940-g.
3. Potez 63.11 Part 2: Escadrille, GR I/52 No. 4 (N357), 1940.
4. Potez 63.11 part: GAO I/583 number: 1 (N?) Aleppo, Syria early 1941.
5. Potez 63.11 Free French Fighter Flight No.2, RAF Serial: Ax673 Haifa, December 1940.
6. Potez 63-11 Part: not available number: G-717 Aircraft was used as a training (for advanced training) in 1943, the ' G ' Prefix in a side room means ' Gyarkori ' camp. 1943 g. like many other aircraft, it was used as an auxiliary.
7. Potez 63-11 part: Reggia Aeronautica Room: no data 1943 g. Note that typically Italian aircraft were not under the wings of
white boxes under the markings. Apparently in this case, they are closing the OZ the previous owners. This type of aircraft was
used only for training and usually carried two white strips on the wings-belonging of flight school.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.