1/72 Wet Decals - Curtiss SB2C Helldiver (1 sheet)

Type: water-slide decals
1. A-25A-10-CS part: 13th FS USAAF number: 41-18826 1944-1945 years. The aircraft cabin with a lantern of the old model.
2. SB2C-4E of VB-87 from the USS Ticonderoga on 29 May, 1945 with empty bombrack and rocketrails.
3. SB2C-1C Unit: VB-2, US Navy Serial: 18 CV-12 USS Hornet on 3rd July 1944.
4. SB2C-4E of VB-84 during Bunker Hill Tokyo Raids of 16-23 February, 1945.
5. SB2C-5E of the Aeronavale Esc 3F in Vietnam 1954.
6. Curtiss SB2C-3 of VB-3, USS Yorktown (CV-10), February 1945.
7. SB2C-4 'Baby II' Unit: VMSB-244 'Bombing Banshees' Serial: 702 Mindanao in June, 1945.
8. SB2C-5 part: VA-11A, US Navy number: 312/V CV-45 USS Valley Forge, 1947.
9. Curtiss SB2C-3 Helldiver of Bombing Squadron 14, VB-14,a board the carrier USS Wasp, August 1944.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.