1/72 Nakajima Ki-27 Nate Decals

Type: water-slide decals

1. Ki-27b No.9 from 3 Chutai 13. Sentai, Japan, 1942

2. Ki-27b of Taii Hyoe Yonage, commander of 2. Centai, the Philippines, December of 1941

3. Ki-27b from 1. Chutai 13. Sentai, Japan,1939. White katakana Ho marking on rudder

4. Ki-27b from 2. Chutai 4.Sentai, Ozuki,Japan 1942-1943

5. Ki-27b from 2. Chutai 204.Kyody Sentai, Japan 1942

6. Ki-27b No.3 from Foong Bin Khap Lai 16. Thailand Air Force Kong Thap Arkart Thai, Lampang, Thailand, November of 1944

7. Ki-27b No.4 from Foong Bin Khap Lai16. Thailand Air Forces Kong Thap Arkart Thai, Lampang, Thailand, November of 1944

8. Ki-27b in Mandzukuo Manshu Kokugun Hikotai air force camouflage, Manchuria, September of 1942

9. Ki-27b from 1. Chutai 64. Sentai, Maruta Butai, China 1940. Gunso Shigeru Takuwa flown this plane. Aircraft has dismounted cockpit shield.

10. Ki-27b No.4 from 1. Kyoiku Hikotai 1944

11. Ki-27b from 3. Chutai 50. Sentai the Philippines, January of 1942

12. Training Ki-27b from 25. Kyoiku Hikotai, May of 1944

13. Ki-27b from 14. Kyoiku Hikotai, November of 1944. Black and white hiragana So. on rudder.

14. Ki-27b No.1 from Tachiarai Rikugun Hiko Gakko, Tachiarai, Japan 1943

15. Ki-27b from 2. Chutai 244. Sentai, Japan.1943. Probably Gunso Tadao Sumi flown this plane

16. Ki-27b from 2. Chutai 244. Sentai,1944-1945.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.