Print Scale 72-059 1/72 US Navy F-4 Phantom Mig Killers (Part 2) Decals

Type: water-slide decals

1. F-4S BuNo 158360 122 assigned to Lt Rich Bryant 'Mink' and Lt Cdr Herzog Whitey, VX-30 Bloodhounds Camouflage:FS36375 dark ghost grey and FS36320.

2. QF-4N BuNo 153030 145 assigned to Lt Cdr LC 'Shantini' Shanle and Lt Brad 'Nacho' Botkin VX-30 Bloodhounds Camouflage: red FS 31120.

3. F-4J ZE361 P assigned to Flt Lt Allchorne and Flt Lt Walsh of No.74 Squadron, RAF Camouflage:Top FS 36440; upper surfaces of fuselage and outer wing panels Flint Grey FS 36314; and upper surfaces of inner wing panels FS 36270 light ghost grey with a black anti-glare.

4. F-4J BuNo 153778 AA 202 of VMFA-451 Warlords Bicentenial Scheme 1976 Camouflage: Top FS 36440 bottom FS 35237.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.