1/72 Fairey Swordfish (complete set, 2 leaf) Decals

Type: water-slide decals

1. L2720:680 of 821 Squadron, Fleet Air Arm, on board HMS Ark Royal, February 1939.

2. Fairey Swordfish I K 6009:912 of 822 Sguadron, HMS Furious, 1937-39.

3. Fairey Swordfish I floatplane K5959;809 823 Sguadron, HMS Glorious 1937-38.

4. Fairey Swordfish I K8449;649 820 Sguadron, HMS Courageous, 17 October 1938.

5. Fairey Swordfish floatpane P4199;E8F, 702 Sguadron, HMS Resolution December 1939. Scheme 2.

6. Fairey Swordfish I L7647:4H 820 Sguadron, HMS Ark Royal, 1941. Scheme 3.

7. Fairey Swordfish ll LS274;1F of 818 Squadron, 1945. Modified Type C1 roundel and fin flash for operations in Far Eastern waters, Scheme 4.

8. Fairey Swordfish lll NF374;NH-M, No-119 Sguadron, RAF, based at Bircham Newton, 1945.

9. Swordfish Mk.II 816 NAS, FAANumber: S (NF243)July 1944 Camouflage fuselage and lower surfaces - white, upper surface - the old standard color. The aircraft is marked with a thin band of white invasion okaemkoy on the fuselage and wings. Markings on the fuselage - the type C1, on the upper wing - type B, on the ground - no.

10. Swordfish Mk.III Part: 119 Sqn, RAF Number: NH-F (NF410) Knocke, Le Zoute, Belgium, 1945 The aircraft is equipped with ASV radar and armed with 113 kg bombs. Painted entirely in black. Squadron machines used against E-and R-boats (), Were about the Dutch coast.

11. Fairey Swordfish l L2817;T4F 767 Sguadron, Kalafrana, Malta September 1940. Scheme 2.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.