Print Scale 72-022 1/72 Hawker Hurricane Decals

Type: water-slide decals

1. Hurricane I, H-25 of Escadrille2, Belgian Air Force, 1940.

2. Hurricane trop Mk IIA (Z5252, ?01?). The plan of northern aircraft General-major A.A. Kuznetsova, Vajenga, area of Murmansk, October, 1941.

3. Hurricane Mk IIc, LD118/A Yugoslav Squadron, RAF, Libya, 1944.

4. Hurricane IIC, Hc465 of LLv 32 in April 1941 in Lappeenranta. On 18 June, 1941 a 50 cm wide yellow band was painted on the rear fuselage and also the under surface of the wing was painted yellow (1/6 of the wing span)

5. Hurricane Mk. II, a board ?1?. by this plane in June 1941 pilot Hirija Agarichi has brought down two SB-2 in area Konstantsyju the standard RAF camouflage. Nose of plane and edge of wings - yellow.

6. Hurricane Trop Mk. I.A. (Z2899) - the first Hurricane, delivered to the USSR by sea, on September. 22-nd 1941, before the plane filed in Night Squadron RAF, therefore has been entirely painted in black color. Technical stencil of red color.

7. Hurricane IIC, No I (Fighter) Squadron, Royal Indian Air Force, Imphal, Assam 1944. Dark green and ocean grey upper surfaces with medium sea grey lower surfaces. Tail, wings and stabilizer bands white.

8. Hurricane Mk.IIC, 3 Squadron, RIAF, presumably 1945. Dark green and ocean grey upper surfaces with medium sea grey lower surfaces. Tail, wings and stabilizer bands white.

9. Hurricane Mk IC, No I (KZ886), 2 Squadron, Marsa Matruh,1944 Egyptian Air Force. Dark earth, mid stone, and azure blue camouflage with sky spinner.

10. Hurricane Trop. Mk I, Z4434. Belonged to group of aircraft of Free France ?Brittany?, Northern Africa, 1942. The plane in standard deserted camouflage RAF: Dark Earth and mid stone on the top wings and Sky Blue on bottom.

11. Hurricane Mk.IIb, 64 sentaj. Number: there are no data. Chiang-May, March, 1042. Has been grasped in Malaya.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.