1/72 Supermarine Spitfire Mk.VIII Series Decals Part 1

This sheet contains markings for 6 different Spitfires operated by different air forces in 23 theatres. The sheet is thoroughly researched and beautifully printed by Cartograf. Complete with 2 full sets of stencils including door stencils and bomb markings and full colour instructions.

Spitfire Mk. VIII, Serial JF349 HL-K 308th Fighter Squadron, 31st Fighter Group, 15th Air Force, USAAF. Pilot - CO of 308th FS. Flown by Lt. Leland P. Molland. Castel Volturno, Italy. February, 1944.

Spitfire MK. VIII, MT982 UM-C 152 Squadron RAF. SEAC. Flown by Warrant Officer Eric Clegg. Sinthe Airstrip, Burma, 1945

Spitfire Mk. VIII, A58-517 (RAF serial MT594) UP-F 79 Squadron RAAF. Flown by Flt. Lt. Norman Turnbull (surname legally changed in August to Smithells). Based at Morotai, Indonesia. Late Spring, 1945.

Spitfire Mk. VIII, JF476 QJ-D 92 Squadron RAF. Desert Air Force. Pilot unknown. Based at Taranto, Italy. September, 1943.

Spitfire Mk. VIII, JF835 UM-T 152 Squadron RAF. SEAC. Flown by Flying Officer Paul "Gus" Ardeline. Sinthe Airstrip, Burma, 1945

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softener is also recommended at this stage. After applying softener, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.