Model Planes

Besides the ladder specific only to the Israel air force which we already sell, here is for you also the original French type to come with your SMB-2 model. Used not just in France, was delivered Israel too...

Limited release of model kit SH48238 which also contains a publication on Israeli SMB-2s and 3D-printed addition...

This is a plastic model kit, which comes unassembled and unpainted. So glue, model paints and other basic modelling tools are additionally required.Modern Italy, Netherlands..

The set contains highly detailed cast resin thrust reverser plates that replace the original kit plastic parts. The thrust reverser is a striking component of the Viggen fighter and it helps to the plane's excellent landing capabilities...

Coloured photo-etched set..

..

..

..

Pre-cut spray mask for the distinctive spliter colour scheme worn by two seater Viggens...

3D-printed hot seats with pilot's harness already in situ...

Coloured photo-etched set..

..

Coloured photo-etched set..

Contains highly detailed cockpit for US jet aircraft. The set contains color photo-etched parts...

..

This is a plastic model kit, which comes unassembled and unpainted. So glue, model paints and other basic modelling tools are additionally required...

3D-printed parts of this set portray the Japanese project of piloted ram missiles planned to destroy the high flying B-29 bombers or other similar targets. The kit contains two versions of the missiles and their transport trolleys...

Paint Mask:Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model ..

The SMB-2 jets were delivered to Israel as an air superiority fighter. In this role they were soon superseded by their successor, the new Mirage IIIC delta jets and so the Super Mysteres were given a new role as fighter bombers which suited them very well due to the ability to carry heavy payloads. ..

Detailed cast resin pilot's seat for a Hurricane fighter aircraft model released by Airfix...

..

These wing flaps have been tailored to fit the Hasegawa kits of the British Harrier GR.7 and the US AV-8B Harrier II vertical take off and landing (VTOL) jets. The flaps can be attached in the down position, very often seen while the machine standing on the ground (or board)...

This is a plastic model kit, which comes unassembled and unpainted. So glue, model paints and other basic modelling tools are additionally required...

This is a plastic model kit, which comes unassembled and unpainted. So glue, model paints and other basic modelling tools are additionally required...