Model Planes

This set includes the detonation cords for the forward and aft canopy pre-cut in self adhesive gray vinyl. Designed to fit the canopy of the Kinetic kit...

Set of four (4) 3D printed launchersThe LAU-7F/A was first introduced in 2008, with more widespread use by 2010. This version is used primarily on USMC F/A-18C/D aircraft...

In February of 1964, the LAU-7A/A was introduced as a USAF version of the LAU-7/A that incorporated provisions for launching the TDU-11/B Target Rocket.The LAU-7A/A was used interchangeably with the Aero-3B on USAF F-4C/D/E Phantoms.The standoff adapters in this set are designed to fit the Zouke..

In January of 1987, AAC-829 was introduced and by May of 1988, over 6500 launchers had been modified to LAU-7/A-6.Over the course of the next several years, numerous AAC's changed the designation of the launcher to B/A, A-7, B/A-1, as well as a few others. However, all of these changes were either..

This set includes four (4) empty LAU-68F/A pods. The F/A is 11 inches longer than the LAU-68D/A and is used exclusively with the 2.75 APKWS rockets. Pod is used by the F/A-18, AV-8B, AH-1Z, UH-1Y, A-10, F-16 and a number of other aircraft.Rocket tubes are hollow the entire length of the pod to dep..

Designed by Petr Haupt, this set includes two (2) LAU-33 Pods, four (4) Mk-71 Rocket Motors, four (4) Mk32 Mod 0 anti tank / anti personnel warheads with Mk188 Impact Fuzes and four (4) Mk32 Mod 0 warheads with Mk93 proximity fuzes..

This set includes four (4) missile launchers in medium gray 3D printed resin.Missiles come as shown with print supports removed. Some very minor sanding to smooth areas where supports were located may be necessary.Launchers designed by Richard VanZandt of Flight Line Resin..

These Missile Launchers are designed to fit the Hasegawa F/A-18E/F wing tip and work perfectly with the Meng kit with one small modification to the kit part.Launchers come as shown and only a light sanding of the aft end to remove the support nibs is required. Integrated formation light panel fit..

These Missile Launchers are designed to fit the Hasegawa F/A-18E/F wing tip and work perfectly with the Meng kit with one small modification to the kit part.Launchers come as shown and only a light sanding of the aft end to remove the support nibs is required. Integrated formation light panel fit..

Set includes four (4) launchersUse for early F/A-18E/F..

Set includes four (4) launchersUsed to carry and launch AIM-9X and AIM-120B/C..

Set includes four (4) launchersUse for early F/A-18E/F..

Set includes four (4) missile launchers.Used to carry and launch AIM-9X and AIM-120B/C..

Set includes four (4) launchers.Used to carry two LAU-127E/A or LAU-127A/A for dual AIM-9X / AIM-120B/C carriage..

LAU-115C/A is a rail launcher designed for carriage and launch of AIM-7 missiles from F/A-18 aircraft. The launcher is suspended from the BRU-32 bomb racks in the SUU-63 wing pylons. Two LAU-7 or LAU-127 launchers may be attached to the sides of the LAU-115 for carriage of AIM-9 or AIM-120 missiles...