Menu
Your Cart

Decals - 1/32 Stripes for Lozenge

Decals - 1/32 Stripes for Lozenge
Decals - 1/32 Stripes for Lozenge
Decals - 1/32 Stripes for Lozenge
Decals - 1/32 Stripes for Lozenge
Decals - 1/32 Stripes for Lozenge
 Product Details
  • Type: water-slide decals
  • Scale: 1/32 
  • Decals Manufacturer: TECHMOD
  • Sheet Size: 260x180mm 
 Markings Versions
  • Stripes for Lozenge - 3 variants


How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.
General Info
Scale1/32
TypeModel Upgrade/Accessory
SubtypeDecals / Stickers

  • Stock: In Stock
  • Reward Points: 14
  • SKU: TD 32032
  • 1pcs in Stock
MRP: AU$21.95 AU$8.0036% OFF
AU$13.95
"In-Stock" Really Means It
Combine Shipping & Save

Be the first to review this product

Write a Review