US Dollar

1/72 Douglas SBD Dauntless Decals

1/72 Douglas SBD Dauntless Decals
1/72 Douglas SBD Dauntless Decals
1/72 Douglas SBD Dauntless Decals
1/72 Douglas SBD Dauntless Decals
Type: Water-slide decals

1. SBD-2 flown by CDR Howard Young, Commander of the Enterprise Air Group. Upper surfaces are Blue Gray over Light Gray
lower surfaces. Red centered stars are carried in four locations. Pearl Harbor.

2. Douglas SBD-3 ??Dauntless?? Squadron VS-2 aircraft carrier "xington", May 1942.

3. SBD-5 of Flottille 4FB, Aeronavale, Cognac January 1945.

4. Light bomber CAC Wirraway of the No.12 Sqn. RAAF (above) and A-24 Banshee of the No. 27 BAG USAAF (below) became victims of the Japanese strike to Darwin on February,19,1942.

5. Douglas SBD Dauntless representing GCB I/18 'Vendee' (Groupe de Chasse Bombardment), Armee de l'Air Serial: F/254543 operating from Vannes, November 1944. Note unit emblem right.

6. Douglas SBD-5 Dauntless,NZ 5057(BuNo 36925). of No25 Sqn. RNZAF, crewed by the squadron commander S/L T.J.Maclean de Lange and his radio operator F/O Sewell. Piva airfield, Bougainville, spring 1944.

7. Douglas SBD-5 Dauntless NZ 5056 (ex BuNo36924) of No 25 Sqn RNZAF, crewed by f/ Sgt C.N O??Neil and F/Sgt D.W. Gray.
Piva airfield, Bougainville, spring 1944.

8. SBD-3 from the Air Group off the Wasp participated in att

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.
General Info
Scale 1/72
Type Model Upgrade/Accessory
Subtype Decals / Stickers
  • Stock: In Stock
  • Reward Points: 17
  • SKU: PRS72-112
  • 1pcs in Stock
Print Scale Decals
Print Scale Decals
MRP: US$14.85 Save: US$2.93
19% OFF
US$11.92 (excl. Tax)
"In-Stock" Really Means It
Combine Shipping & Save
SAME or Next day shipping*

There are no reviews

Maybe you can help? Many users will be grateful to you. And so are we.