1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softener is also recommended at this stage. After applying softener, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.
Contents: 1. Ki-44-l of the 33rd Sentai, Canton, China, early 1943.
2. Ki-44-ll Hei of WO Makoto Ogawa, 70th Sentai, Kashiwa, Japan, 1945.
3. Ki-44-ll Hei ??Asakaze?? of the 2nd Chutai, 104th Sentai, Mukden, Manchuria, autumn 1944.
4. Ki-44-ll Hei of Capt Yukiyoshi Wakamatsu, 2nd Chutai Leader, 85th Sentai, Canton, China, summer 1944.
5. Ki-44-ll Hei of Capt Ryotaro Jobo, 1st Field Reserve Air Unit, Singapore, 1944.
6. Ki-44-ll Ko of Capt Yukiyoshi Wakamats, 2nd Chutai leader, 85th Senta, Tien Ho airfield, Canton, China, summer 1943.