TABU Design 06001 1/6 Yamaha YZR M1 Moto GP 2001 Decal

Water-slide Decals:

Instruction:
1.Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2.Cut out the decal you need (do it on cutting mat)
3.Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4.Remove the decal from the water and place it on paper towel to remove any excess water.
5.Apply decal solution to the part where the decal is to be placed.
6.Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7.Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softener is also recommended at this stage. After applying softener, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Clear/Future to seal it.