Echelon Fine Details D356043 Decals for 1/35 SdKfz.232 (8 RAD) Wiking Division

Water-slide Decals

Markings for a well-known Wiking 8-RAD on the eastern front. Remember the camouflage-clad waffen-SS soldiers all over it? This is the vehicle, can be literally built OOTB using the classic kit with the exception of removing the splash guards on the upper hull forward and rear of turret. The "sonnenrads" (Wiking sunwheel) are tailored to fit the vehicle type - no more hunting for generic ones that may not be properly sized. Generic VRN plates included, in case you want to go for something similar that doesn't require you to follow the references too closely.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.