Echelon Fine Details D356033 Decals for 1/35 German StuG IIIs on the Eastern Front

Water-slide Decals

More interesting markings for the Stug III fans. This set covers three Stug units on the eastern front: StuG Lehr Batterie 901 (utilising Ausf F-8s); SS StuG Abt "Das Reich" (equiped with Ausf Gs, early type); and PzJgr Abt "Feldhernhalle" 1 (fielding Ausf Gs, also early but with full side skirts). All the markings are accurately reproduced

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.