Water Slide Decals for 1/35 Oil & Gas Station

Features:
water-slide decals with separated film (they come off automatically one-by-one, no need to cut to the edges)
semi-matte finish
covered by a semi-transparent protective sheet
ultra-thin decal will adapt well to any surface
Hi-definition printing gives a crisp result, even in the smallest details colours are accurate and colourfast
1:35 scale, but can also be used for other scales

How to use:
cut out a decal with a sharp knife
put in water for about 5 - 10 seconds to loosen the decal from its carrier paper
gently slide off the decal into position using tweezers
use decal softener (for example Micro Set & Sol) for better adhesion, especially for use on non-flat surfaces
use tissue paper and apply some light pressure over the decal, to remove any excess water/decal softener and fix the decal into position
airbrush some varnish for protection - (semi-)matte varnish can remove the glare if needed start the usual weathering process to blend into your design