Scale Motorsport 7010 1/24 Mitsubishi Lancer Evo Composite Fiber Template for Tamiya #24220

This Composite Fiber Template Set for the Mitsubishi World Rally Car is designed for use with the Tamiya 24220 Mitsubishi WRC plastic kit.

This carbon fiber decal set contains one sheet of #1224 and one sheet of #1024 with a total of number of 30 template forms in the set. Corresponding parts to be covered are the interior door panels, dashboard inserts, rear trunk wall, seat shells, plus many others. Each template part is numbered to correspond to the associated Tamiya part number.

We recommend using Microscale's "Micro-Set" Softening solution with all SMS's decals.

This set contains 5 Sheets with a total of over 80 templates including 3 sheets of 1424 Plain Weave and 2 sheets of #1020 Twill Weave.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.