WIP3D 35131 1/35 M548 Volcano Conversion Kit

Products made in 3D are not assembled or painted, and colour differences may occur depending on the resin used.

Experience in removing 3D parts can be helpful but is not essential. Any supports attached to the detailed areas can be cut with side cutters or a slitting disc, and the remaining parts can be removed with snips or by applying pressure with a fingernail. Due to the extremely fine detail, great care must be taken to avoid breakage.

Keep out of strong light until removed from the pad and primer is applied. Exposure to light may continue to cure the items, which could cause them to warp or become brittle. The pads may curl slightly (even when kept in the dark) due to stresses in the resin from the printing process.
Caution: Never boil in hot water, as this can cause damage. If the product is bent, the heat from a hair dryer can help to straighten it.