Decals for 1/35 British Armour / AFV Tanks in Normandy 1944

Decals for British tanks and AFVs in Normandy 1944:

Sherman Mk II, 44th RTR, 'Rebel"
Sherman Mk II Hybrid, 3rd County of London Yeomanry
Sherman Mk III, Nottinghamshire Yeomanry, 'Akilla'
Sherman Mk III, 24 Lancers, 'Armageddon'
Sherman Mk Vc Firefly, 4th County of London Yeomanry, 'Allkeefek'
Willys Jeep, 21st Army Group
White Scout Car, HQ 11th Armoured Division
Humber Scout Car, 1st Army Tank Brigade
Humber Scout Car, 33rd Armoured Brigade

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.