1/35 Novorossian AFVs (Ukraine - Russia Crisis) Decals Part 10: BRDM-2 and BMD-2

Type: water-slide decals

One very large shark marking for one of Vostok Battalion's BMD-2 with interesting camouflage. Due to complex surface of the BMD's lower front hull, extra care has been given (with precise measurements taken) to make sure the shark mouth is accurately captured. Another BMD-2 with standard Russian camouflage patterns with interesting markings. Two BRDM-2s, one with shark markings and 3-tone camo, the other with large CCCP markings, all saw action in the eastern Ukraine against the Ukrainian forces.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softener is also recommended at this stage. After applying softener, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.