Echelon Fine Details D356147 Decals for 1/35 Merkava Siman 3D (Part3)

Type: water-slide decals & Photo-etched Parts.
Two specific Mk 3D vehicles which fought in 2006 Lebanon War. The stylings of markings are unique to each vehicle. Marking option one comes with turret tactical markings (3 Bet) that is different from it's hull (2). This is a not a mistake and is supported by photography references that are listed on the instruction sheet. For example, check out Getty Image 57079053. Comes with extensive generic data plates and stencils. All the stencil markings are pain-stakingly created, using none of the computerised hebrew fonts out there. And a photo-etched set to tackle raised registration plates and optional detail parts to boot. Also included are stencils for the 7.62mm M19A1 & .50 Cal M2 ammo box labels. For the crew, two verison of flag patches. Two sizes of antenna flags are also provided. All you need in one set.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.