1/35 Decals for US Army OH-6A Cayuses in The Vietnam War: Loach - Low Level Scouts

Note: This set does NOT include aircraft kit.

This 1/35 decal sheet includes 24 marking options for US Army OH-6A Loaches:
D Troop, 1st Squadron, 1st Cavalry Regiment (x3)
A Troop, 7th Squadron, 1st Cavalry Regiment (x2)
D Troop, 3rd Squadron, 4th Cavalry Regiment
F Troop, 4th Cavalry Regiment
F Troop, 8th Cavalry Regiment
C Troop, 1st Squadron, 9th Cavalry Regiment (x2)
D Troop, 1st Squadron, 10th Cavalry Regiment
A Troop, 2nd Squadron, 17th Cavalry Regiment
B Troop, 2nd Squadron, 17th Cavalry Regiment
C Troop, 3rd Squadron, 17th Cavalry Regiment (former D Trp, 3rd Sq, 5th Cav)
B Troop, 7th Squadron, 17th Cavalry Regiment (x2)
C Troop, 7th Squadron, 17th Cavalry Regiment
B Troop, 25th Aviation Battalion
B Company, 123rd Aviation Battalion
Casper Platoon, 173rd Airborne Brigade
326th Airborne Medical Company, 3rd Brigade, 101st Airborne Division
HQ Company, 3rd Brigade, 101st Airborne Division
Unknown unit (x2)

Two sets of stencils provided which also include interior markings.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softener is also recommended at this stage. After applying softener, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.