Decals for 1/32 USAF OV-10A Bronco FACs in Vietnam War "You're cleared in hot!"

Note: This set does NOT include aircraft kit.

This 1/32 decal sheet includes 16 marking options for OV-10A Broncos used by the USAF in the Forward Air Controller (FAC) role during the Vietnam War. Unfortunately not all schemes included are identified to their applicable assigned Tactical Air Support Squadron (TASS). Although not illustrated, one aircraft (67-14623) can also be modeled as a PAVE NAIL aircraft since the markings were the same before/after modification.

Instructions also include ordnance loadout charts.

Full stencils are provided for one OV-10; however, the stencils provided are complete airframe stencils. The stencil sheet which can be separately purchased from set AOA 32-007.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.