Decals for 1/35 101st Airborne Humvees in Iraq

Type: water-slide decals
Covering markings for 3 101st AB units that saw action in Iraq (OIF): 327th, 187th and 506th. Prominently displayed are the unit's adopted markings, some of which are also applicable on other vehicle types fielded by each unit.

Also included are the first time ever miniature car window flag decals that you place from the inside of the vehicle against the windows. It is reverse printed on the decal sheet - you just need to slide it off onto the front windscreen of your Humvee model from the insde (not outside).

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.