Decals for 1/35 M1A1s in ODS (Tanks of 3-67 Armour "Tiger Brigade")

Water-slide Decals

Looking for an interesting ODS M1A1 to build? Well, look no further, here is the first of the (hopefully) few to come as ODS information are pretty scarce as it is, nevermind interesting. Complete all-round vehicle information is even harder to find. Well, those days there were no such thing as a "digital" camera...

Belonging to the 3-67 Armor (Tiger Brigade), this M1 feature a wolf's head(?) on both sides of the vehicle, making it an interesting subject to model. This decal set provides 2 alternative markings for one complete build. And don't throw your T156 (chevron type) tracks away just yet, you'll need them for this build.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.