1/24 Ferrari FXX-K Carbon Pattern Decals Set for Tamiya kit #24343

Add a greater layer of detail to your 1/24 FXX K static model with this set of decals. These decals recreate the fine carbon patterns found on the Ferrari hybrid racetrack car. The decals provide a far less stressful option than recreating the pattern using difficult painting techniques. Use them to depict carbon material surfaces on the rear of the car, the engine room, and even the interior.

- For use with TM 24343 1/24 Ferrari FXX K.
- 1 sheet contains 2 different carbon patterns.
- Decals are numbered on the paper backing for ease of location and application.
- Instructions included.

Water-slide decals

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softener is also recommended at this stage. After applying softener, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.