1/35 Novorossian Antenna Flags Part 3 (water-slide decals)

Type: water-slide decals

Second variation of the double headed eagle design. The set provides two flags. One complete with black/blue/red background. The other without the background so that there is versality of creating flags using other materials. E.g. Rolled two-part epoxy putty, etc. Another flag that is cramped with a lot of details which took great pain and time to create. A number of units carried this flag on their AFVs.

The set also comes with 7 smaller flag stickers.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softener is also recommended at this stage. After applying softener, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.