1/48 Mikoyan-Gurevich MiG-19 Farmer Decals

Type: water-slide decals

1. MiG-19 PM, a board 335. Museum of the Air Forces of GDR, Berlin-Gatov.1980.

2. Mikoyan/Gurevich MiG-19 ?24 red? of the 33rd IAP based at Wittstock AB was flown by Capt. Fyodor Zinov?yev against the RB-66 which intruded into East German airspace on 10th march 1964. The plan had standard painted for this type - all silvery.

MiG-19 sans suffixes ?27 red?, 35th IAP. This fighter was flown by Capt. Vitaliy Ivannikov when he intercepted the intruding RB-66 on 10-th March 1964 and turned the destroyer into a destroyed. Later MiG-19 sans suffixes ?27 red? had a single ?kill? star applied on the port side under the cockpit to commemorate the shoot down.

3. A two tone Gray camouflaged F-6, 19 Squadron, Pakistani Air Force. The aircraft is a late production F-6 with Pakistani modifications including the deletion of the antenna mast under the cockpit and the addition of AIM-9 Sidewinder rails on the outboard wing panels.

4. Bangladeshi F-6, Black 7104. Is armed with seven shot rocket pod and two 200 gallon (760 liter) underwing fuel tanks. It is a late production F-6 with the bullet shaped braking parachute container at the base of the rudder and N-30 cannons without gun gas defectors on the muzzles.

5. Shenyang F-6s of the Commanders School area Swat hills near Sargodha, Pakistan. The plane is armed by AIM-9P Sidewinder infra red homing air-to-air missiles on the outboard wing pylons.

6. Shenyang F6, Pakistan Air Force

7. Lim 7 (MiG-19 PM Farmer E) of the 28 Pulk Lotnictwa Mysliwskiego ( 28th Fighter Regiment) Slupsk-Redzikowo, Poland, 1980. Plan is overall Natural Metall. Polish aircrafts did not carry the national insignia on the wing upper surfaces.

How to apply water-slide decals:
1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
2. Cut out the decal you need (do it on cutting mat)
3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
4. Remove the decal from the water and place it on paper towel to remove any excess water.
5. Apply decal solution to the part where the decal is to be placed.
6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.