1/35 Photo-etched Stencil for Kangaroos and Scorpions

How-to:
Preparing the masks: Masks should not be stretched during the application process as they are flexible and this could cause deformation. Remove the whole mask if necessary, and then apply again. Once placed on the model, the mask surface should be adjusted to the surface of the model by tracing all the indentations with a pointed wooden stick.
Painting method: Try not to apply two coats of colour at the edges of a mask. Instead, apply one colour prior to painting the proper camouflage, and apply the other colour after the mask is back on. Otherwise, the coating in the areas encased by the mask may be too thick, and after removing the mask the edges of the lighter colour may become visible.

The stencil shows:
- Kangaroos in several sizes
- A map of Australia seen on some M113a1s in Vietnam
- The (yellow) 1 ATF shield in Vietnam
- 3 Cavalry scorpion used in Vietnam - 2 sizes.

The kangaroos stencil can be used on rough and surfaces where decals will not adhere.
The right hand images shows the stencil used on a piece of plastic sheeting.