Next Dispatch will be in
Login  or  Register

Decals for 1/35 US Army (1-64 Armour, A Co) M1A1HAs in "OIF"

Manufactured by: Echelon Fine Details

SKU: EC T35014
Price: AU$17.95

US$12.03;  €10.95
earn: 16 BNA points
Availability: tick In Stock
Order Quantity:

Add to Cart
Accepted payment methods: PayPal, credit card and bank deposit

  SSL Secured VeriSign Trusted
  • Combine Shipping & Save
  • Order by 3pm EST for same day shipping! (Mon - Fri)
  • Ask a question

    Product Description
    Water-slide Decals

    A full 1 + 1/3 sheet to cover complete markings for 7 M1 Abrams out of the 1-64th Armor. Featuring the 2nd platoon, 4 gun tanks in full, whose barrels were marked after the 4 airline jets - a tribute to the September 11th, 2001. A memory that's still clearly etched in our minds...

    The remaining markings: 1 vehicle from 1st platoon (red barrel ring), and 2 others from 3rd platoon (black barrel rings).

    This sheet attempts to get the markings as accurate as possible down to the different chevrons and "squares" used.

    Also included is a flag sheet. The medium and large flags are antenna flags that are needed to wrap around the antennas of some of the featured M1s. The smallest flags represent a "sticker" form found on one of the M1s.

    Lastly, as a bonus, a patch sheet enough for 4 tanker figures. These are very hard and costly to print as the details are extremely fine.

    How to apply water-slide decals:
    1. Preparation: to achieve better result, a gloss or semi-gloss coat is very important. It will make a smooth layer which the decals will suction to and make it much easier to apply and set them.
    2. Cut out the decal you need (do it on cutting mat)
    3. Grab the decal with tweezers, place it on the surface of the water and leave it for about 20 seconds.
    4. Remove the decal from the water and place it on paper towel to remove any excess water.
    5. Apply decal solution to the part where the decal is to be placed.
    6. Slide the decal off the backing paper on to the model. Using a paint brush or cotton bud is a good way to do this without damaging the decal.
    7. Use the brush, knife or cotton bud to position the decal. Using your paper towel, gently dab the decal and soak up the excess water (decal softner is also recommended at this stage. After applying softner, the decal will suction to the part and flatten out smooth.)
    8. When the decal is completely dry, give another coat of varnish or Klear/Future to seal it.

    Suggested Tools

    Customers who bought this item also purchased...